Posted on Leave a comment

THURSDAY IS ALL ABOUT THE 3D PROJECT

For today’s 3D project I wanted to create a triangular gift box.

Each of the sides measures 3 3/4″x 3 3/4″. The base and lid triangles are 3 1/4″ with half inch flaps on each side.

A small note about two-tone card – when it is cut you can see the white core.

I cut three of the outline arched shaped from another of the DSP designs.

Using a paper piercing tool, I made two small holes to thread some white baker’s twine through so that I could secure the lid.

I cut a slightly smaller triangle for the lid and stamped the greeting and decoration.

The 2025-2027 In Colour Flat Pearls were popped on top of the small sunburst.

I’m not sure what I will pop inside the box yet but it will be tasty!

Tomorrow I have three more cards to share with you.

Until then, happy stamping and scrapbooking.

If you live in Australia, you can order any of the products I used to make this card by going to my online store. Just click on any of the images below.

Product List
Leave a Reply

Your email address will not be published. Required fields are marked *